Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Piaggio Vespa Gts 300
Part: Key

This guide briefly explains the instructions for removing and replacing the battery of the key fob for the Piaggio Vespa GTS 300 scooter. First, take the key fob in hand and start by removing the plastic rear cover by prying at the side slot; then remove the battery found inside and replace it with a new one (of the correct type and with the same code), as shown in the video. Insert the battery the correct way round and reassemble the key fob, checking its proper functioning.

Posted on 19 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery of the Piaggio Vespa GTS 300
How to Replace the Battery of the Piaggio Vespa GTS 300
Vespa Gts 300 Briefly review the instructions to remove and replace the battery of the Piaggio Vespa GTS 300 scooter. First, place the scooter on the centre stand …
How to Reset the Service on a Piaggio Vespa GTS 300 Scooter?
How to Reset the Service on a Piaggio Vespa GTS 300 Scooter?
Vespa Gts 300 As shown in this tutorial, resetting the service on a Piaggio Vespa GTS 300 scooter is an extremely simple and quick operation. Before proceeding, en…
How to Replace the Battery on the 2021 Vespa GTS 300
Vespa Gts 300 In this video, you will see how to remove and replace the battery on a 2021 Piaggio Vespa GTS 300, following these simple steps. First, remove the sc…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos