Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Start by unscrewing the 13 mm nut that secures the cable to the rear brake, as shown in the video. Once done, pull it firmly without hesitation, extracting it from the various passageways. Lubricate and unscrew the 10 mm nuts that secure the bracket underneath the footboard and remove the pedal from its housing (remove the rubber on top). Disconnect the two wires related to the stop lights and detach the brake cable. If you find it too difficult to pull, break the hidden clips shown in the video. Remove the pin from the pedal assembly and slide out the cable. Proceed in reverse to install the new cable.

Updated on 11 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Throttle Cable on a Piaggio Vespa PX 125
How to Replace the Throttle Cable on a Piaggio Vespa PX 125
Vespa Px 125 This guide will illustrate the procedure for disassembling and replacing the throttle cable on the Piaggio Vespa PX 125. First, place the central sta…
How to replace the clutch cable of the Piaggio Vespa PX 125
How to replace the clutch cable of the Piaggio Vespa PX 125
Vespa Px 125 Today we will discover the instructions that will allow us to disassemble and replace the clutch cable of the Piaggio Vespa PX 125, as well as the PX…
How to Replace the Speedometer Cable on the Piaggio Vespa PX 125
How to Replace the Speedometer Cable on the Piaggio Vespa PX 125
Vespa Px 125 This guide explains how to remove and replace the speedometer drive cable on the Piaggio Vespa PX 125, as well as the PX 200 and PK 50. First, discon…

How to Reset the Service Light on the Yamaha Xmax 250?

To reset the service light on the Yamaha Xmax 250, you need to insert the ignition key into the appropriate slot, so that you can turn it and switch on the instrument panel. Once this is done, press and hold the central button located on the left side of the instrument panel: the button should be held for about 20 seconds. When released, you will notice that the flashing service light has turned off: to verify that the reset has occurred correctly, you will need to switch off and then switch on the vehicle's instrument panel.

Watch the video!


by ScegliAuto

More videos