Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video tutorial, you will see how to replace the transmission oil on a Piaggio Vespa GTS 300, following the instructions below. First, position the central stand on your scooter and start by uncovering the transmission oil drain plug by turning the rear wheel; then remove the screw and let the oil drain into a container using a Torx spanner. At this point, use a 10 mm spanner to unscrew the drain screw and the upper dipstick, then add the new gear oil; fill it up to the maximum level!

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Gear Oil on a Piaggio Vespa GTS 300
How to Change the Gear Oil on a Piaggio Vespa GTS 300
Vespa Gts 300 To change the gear oil on a Piaggio Vespa GTS 300, you need to loosen the drain plug, which is located at the bottom of the transmission case on the …
How to Change the Engine Oil on Piaggio Vespa GTS 300
How to Change the Engine Oil on Piaggio Vespa GTS 300
Vespa Gts 300 To change the engine oil on the Piaggio Vespa GTS 300, loosen the drain plug of the oil tank, located at the bottom in front of the exhaust. Once the…
How to Reset the Oil Service Light on a Piaggio Vespa GTS 300 Scooter?
How to Reset the Oil Service Light on a Piaggio Vespa GTS 300 Scooter?
Vespa Gts 300 In this tutorial, we will see how to reset the oil service light on a Piaggio Vespa GTS 300 scooter, an extremely simple and quick operation to be pe…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos