Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Air Filter on the Piaggio X10 125

Model: Piaggio X10 125
Part: Air filter

Video tutorial

To replace the air filter on the Piaggio X10 125, you need to loosen the screws that secure the cover located near the rear wheel, above the transmission. Once the screws are loosened, you can open the cover and remove the air filter inside.

When the old filter has been removed, insert a new one and close the cover by securing it with the screws. After installation, start the scooter to ensure everything is functioning correctly.


Updated on 8 June 2026 by ScegliAuto


Related tutorials

X10 125 How to replace the engine air filter on a Piaggio X10 125? Follow this guide to proceed with the replacement. Position the scooter on a central stand…
X10 125 To set the clock on the Piaggio X10 125, turn on the instrument panel by inserting the ignition key into the corresponding slot. Once the panel is on…
X10 125 To replace the headlight bulb on the Piaggio X10, loosen the screws securing the front fairing: these are located immediately above the headlight and…

Replacing the Front Brake Pads on the Triumph Daytona 675

The following instructions will allow you to remove and replace the front brake pads on the Triumph Daytona 675. First, place the bike on a stand and begin undoing the fixing screws of the front brake caliper; apply pressure to the caliper piston to retract it, thus removing the old brake pads, as shown in the video. At this point, clean the caliper of any residual dirt, then install the new original brake pads; reattach the caliper to the disc, replacing the other brake pads in the same manner!

Watch the video!


by ScegliAuto

More videos