Do it yourself
Frequently asked questions about cars and motorcycles
To replace the rear brake pads on a Piaggio MP3 500, first loosen the bolts securing the exhaust to its housing and remove it completely. Once the exhaust is removed, also loosen the screws securing the support at the rear to access the bolts holding the rear wheel. Now, you can loosen the bolts securing the wheel to the swingarm, detach it completely, and access the caliper. The caliper must be released from its housing by loosening the screws and removing the pads inside.

Updated on 28 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Mp3 500 To replace the rear brake pads on a Piaggio MP3, first loosen the bolts securing the exhaust to its housing, removing it to access the components at …
Mp3 500 To replace the front brake pads on a Piaggio MP3 500, loosen the bolts securing the brake caliper, which is located on the inside of the wheel. By lo…
Mp3 500 Below are the main instructions for removing and replacing the rear brake disc of the Piaggio MP3 500 scooter. First, place your scooter on the centr…

How to Replace the Engine Cover on a Honda CB 650R

This guide provides instructions for removing and replacing the engine cover on a Honda CB 650R motorcycle, following these simple steps. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. Then, unscrew all the screws from the cover or engine casing found on the right, as shown in the video. At this point, install the new cover, ensuring to replace the gasket and clean the base thoroughly.

Watch the video!


by ScegliAuto

More videos