Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Piaggio
    3. :
  3. Vespa Gts 300
    4. : To reset the maintenance icon on a Vespa Piaggio GTS 300, follow these steps: 1. Turn on the ignition switch without starting the engine. 2. Press and hold the mode button on the handlebar until the maintenance icon appears on the display. 3. Release the

Model: Piaggio Vespa Gts 300
Part: Checks and maintenance
To reset the maintenance icon on a Vespa Piaggio GTS 300, follow these steps: 1. Turn on the ignition switch without starting the engine. 2. Press and hold the mode button on the handlebar until the maintenance icon appears on the display. 3. Release the

In this video we see how to reset the maintenance icon on a Vespa GTS 300; of course, you can only do this after performing the required maintenance. It will start flashing about 300 km before the service deadline. If it remains steadily on, it means that the maintenance interval has already passed. But let's see how to reset the light (after you have performed the required services): insert the key, you will see the light flashing for a moment and then remaining steady. We need to act on the joystick located on the left side of the handlebar, scrolling through the information until we reach the battery voltage. Now we will press the button three times, but at different intervals. The first will last half a second, the second will last two seconds, and the third will last about ten seconds. At the end of this sequence, the light will turn off. If it doesn't, turn off and on the key and try the whole sequence again, because it may not work on the first attempt.


Posted on 24 November 2023 by ScegliAuto

How to replace the front brake pads of the Ducati Multistrada 1200

Today's guide will show us the main steps useful for disassembling and replacing the front brake pads of the Ducati Multistrada 1200. First of all, we put our motorcycle on the central stand and start unscrewing the fastening screws of the front brake caliper, in order to remove it from the disc; then we remove the two locking pins of the brake caliper, using pliers with pointed tips, as shown in the video. At this point, we remove and replace the brake pads with new ones, of the right type; we first clean the caliper from the residual dirt, thus installing the brake caliper!

Watch the video!


by ScegliAuto

More videos