Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the black sticker from the pillar of a Dodge RAM 1500

Model: RAM 1500 DS, DJ, MK 4 - Years 2009-2019
Part: Body

Did you know that the black color of the pillars of your Ram 1500 is just a sticker, and that underneath it is painted in the color of the body? That's how it is, and you can take it off very easily, as our youtuber teaches us to do. Simply with a body shop hair dryer (but in the limit even a normal hair dryer is fine) you just have to heat the surface of the plastic, and remove it slowly, so that it comes off without breaking too much. You must do this on both the front and rear pillars, on both sides. Then give a good degreased and polished as it should and the job will be done.

Posted on 23 July 2022 by ScegliAuto

Video tutorial

Related tutorials

Replace the starter motor on the Dodge RAM 1500
Replace the starter motor on the Dodge RAM 1500
RAM 1500 (1994-2001 / BE, BR, MK 2) Let's replace the starter motor of the Dodge RAM 1500 together, following the instructions below. First of all we open the bonnet and we go to discon…
How to reset the multimedia system of the Dodge RAM 1500
How to reset the multimedia system of the Dodge RAM 1500
RAM 1500 (2019-2026 / MK 5, DT) Today's steps will show us the process of resetting the factory radio and multimedia system of the Dodge RAM 1500. First, we get on board the vehicle…
How to replace the battery on the Dodge Ram 1500 MK4
How to replace the battery on the Dodge Ram 1500 MK4
RAM 1500 (2009-2019 / DS, DJ, MK 4) In this short and simple guide we will see how to remove and replace the battery of the Dodge Ram 1500, fourth generation. First we open the engine h…

Removing the Timing Belt on a Suzuki Vitara

In this video, see the removal and replacement of the timing belt and water pump on a Suzuki Vitara. Open the bonnet and lift it, securing it in place. Use a socket wrench to remove the cooling radiator along with the associated hoses. Disconnect the power wiring using pliers, and remove the plastic undertray with a screwdriver. Use a spanner to loosen the tensioner pulley and slide the belt off its seat. Use a socket wrench to unscrew the tensioner pulley bolt, and remove the water pump as shown in the video. Fit the new water pump, the tensioner, and the belt itself, tightening everything with the socket wrench. Finally, reinstall the radiator with the securing bolts.

Watch the video!


by ScegliAuto

More videos