Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Front Shock Absorber Replacement

Model: Renault Laguna MK III, Laguna 3, MK 3, Laguna III, X91 - Years 2007-2015
Part: Shocks

You only need an 18 mm socket spanner for this operation. Remove the wheel and undo the nut that secures one end of the shock absorber to the vehicle's chassis. First, secure the entire suspension arm assembly to prevent it from dropping during the operation. Position the vehicle on a ramp and remove the retaining pins from the suspension arm cover. Undo the bolt that secures the shock absorber to the steering arm using an 18 mm ratchet spanner and remove the worn suspension. Attach the new shock absorber to the base and then to the chassis.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Rear Shock Absorber Replacement
Rear Shock Absorber Replacement
Renault Laguna (2007-2015 / MK III, Laguna 3, MK 3, Laguna III, X91) Replacing the rear shock absorbers is extremely simple and does not require access to the boot for removal: everything is done from the outside; lift…
Instructions for Replacing the Drop Link
Instructions for Replacing the Drop Link
Renault Laguna (2007-2015 / MK III, Laguna 3, MK 3, Laguna III, X91) If you notice noise from the front end while driving over rough terrain, it is likely that the drop link (commonly known as the stabiliser link) conn…
Front Shock Absorber Replacement
Front Shock Absorber Replacement
Renault Laguna (2007-2015 / MK III, Laguna 3, MK 3, Laguna III, X91) Remove the affected wheel and place your vehicle on axle stands for easier access. Now, undo the bolt located at the end of the lower spring to detac…

How to Replace the Lambda Sensor on an Opel Corsa

First, release the bonnet using the lever and lift it to access the front of the engine between the bumper and the engine, where the exhaust gas collectors are located. The lambda sensor is positioned here. To remove it, use a socket wrench to unscrew the sensor head and extract it to check its condition. If necessary, replace it with a new part. To reinstall, connect the new sensor to the connector and screw it into the correct position.

Watch the video!


by ScegliAuto

More videos