Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Panel of the Renault Clio 2

Model: Renault Clio Clio 2, MK 2 - Years 1998-2005
Part: Door trim panel

Removing the rear door panel on this Renault model is very simple and does not require special precautions; start by removing the speaker protection grille by turning it counterclockwise to unclip it; then lever at the base of the window winder to extract it from the pivot and finally unscrew the various screws securing the panel to the door; once all screws are removed, unclip the pressure clips and complete the removal of the panel by pulling it upwards to slide it out of the window seal.

Updated on 10 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Door Lock Actuator from a Renault Clio
How to Remove the Door Lock Actuator from a Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) This guide shows how to remove and replace the door lock actuator of the front door on a Renault Clio, following the instructions below. First, open …
How to Remove the Right Door Panel on a Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) In this video, we will see how to remove the passenger side door panel on a Renault Clio. To start, unscrew the securing screws on the side of the do…
Remove the right front door panel on a Renault Clio
Remove the right front door panel on a Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) Remove the right front door panel on a Renault Clio: disconnect the window winder, use a screwdriver to remove the screws located in the upper lever …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos