|
Do it yourself
| |||
| ||||
How to Replace the Track Rod Ends on a Renault Megane
Model: Renault Megane
Megane III, Megane 3
- Years 2008-2015
In this video tutorial, you will see how to replace the track rod ends on a Renault Megane by following some essential steps: first, get into the vehicle, turn off the engine, and pull the handbrake. Lift the front of the car with a hydraulic jack and place safety stands under the vehicle. Remove the wheel by unscrewing the bolts to access the steering system. Once the wheel is removed, place it under the vehicle. Use a penetrating fluid to ease the removal of the track rod end. Mark the position between the track rod and the track rod end; this will help later when you disassemble and reassemble it. Use an 18mm spanner and a 25 Torx key to unscrew the supporting bolt of the track rod end. Use a hammer to sharply strike the nut you have unscrewed. To detach the track rod end from the pin, push on the pin of the track rod end only if you intend to replace it. Unscrew the track rod end, being careful to note the mark and count the necessary turns to remove it. Use a caliper to measure the distance between the lock nut and the track rod.
Updated on 11 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Megane
(2015-2023 /
Megane 4, Megane IV)
Before you can start, sit in the driver's seat of your Renault Megane 1.6 diesel. Connect your laptop to the car and launch the specific software. Ne…
Renault Megane
(2015-2023 /
Megane 4, Megane IV)
Changing the system language on your Renault Megane Mk4 is very simple. With the instructions in this new guide, you will complete the operation with…
Renault Megane
(2008-2015 /
Megane III, Megane 3)
In today's video, see how to remove and subsequently replace the injectors on the Renault Megane. First, it is recommended to work only when the engi…
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.489
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |