Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Engine Oil Pressure Sensor

Model: Saab 9 3 MK 1 - Years 1998-2003
Part: Engine oil

This video shows how to replace the engine oil pressure sensor. The sensor is replaced either when it leaks oil or when the warning light malfunctions. Once the car is raised and all necessary plastics are removed, locate the sensor, disconnect the wiring, and unscrew it using a 24mm spanner. When installing the new sensor, pay attention to the tightening as the correct pressure is needed to seal and compress the new washer.

Updated on 9 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Engine Air Filter, Oil Filter and Oil
Replacement of Engine Air Filter, Oil Filter and Oil
Saab 9 3 (2002-2014 / MK 2) Once the front bonnet is opened, the engine air filter housing is located on the passenger side: unscrew the fastening screws of the cover, lift it, …
How to Change Engine Oil and Oil Filter
How to Change Engine Oil and Oil Filter
Saab 9 3 (2002-2014 / MK 2) This video shows how to change the engine oil and the oil filter on a Saab 9-3. After opening the bonnet, remove the plastic engine cover secured wit…
How to disassemble the instrument panel of the Saab 9-3
How to disassemble the instrument panel of the Saab 9-3
Saab 9 3 (2002-2014 / MK 2) In these short and simple steps, we will see the process of disassembling and replacing the instrument panel of the Saab 9-3 dashboard. First, we get…

Other guides you may be interested in

How to Fit Seat Covers on a Renault Clio

How do you fit seat covers on your Renault Clio? Watch this video for guidance. First, move the seat forward and raise the seat base, then remove the headrest from the backrest. Slide the seat cover from the top down over the backrest, removing any controls on the side of the seat if necessary by pulling them towards you. After fitting the upper seat cover, ensure it is around the headrest seals. Fit the lower seat cover on the base, pull the springs with the metal clips and secure them. Use plastic spatulas to assist with the fastening.

Watch the video!


by ScegliAuto

More videos