Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the crankshaft position sensor in the Saab 9-5?

Model: Saab 9 5 Ys3g, MK 2 - Years 2010-2012
Part: Crankshaft position sensor

In this tutorial, we can see how to replace the crankshaft position sensor in the Saab 9-5, a very simple and quick operation. First of all, make sure that the engine is completely cold, then open the hood and remove the exhaust manifold cover. Then go underneath the vehicle, locate the sensor on the left side, at about halfway up, and unscrew the corresponding fixing bolt with a Torx T30 wrench. At this point, we can disconnect the connector, remove the sensor, and follow the reverse procedure to install the replacement.

Posted on 20 September 2023 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Crankshaft Position Sensor
Replacement of Crankshaft Position Sensor
Saab 9 5 (1997-2010 / MK 1, Ys3e) If your Saab's engine has difficulty starting when hot, it is likely due to the crankshaft position sensor. The replacement is not particularly diffi…
How to replace the antenna of the Saab 9-5
How to replace the antenna of the Saab 9-5
Saab 9 5 (2010-2012 / Ys3g, MK 2) The steps to replace the roof antenna of a Saab 9-5 car are simple and quick to perform independently. The first step is to check that no water has e…
How do you replace the starter motor on the Saab Nove Cinque?
How do you replace the starter motor on the Saab Nove Cinque?
Saab 9 5 (1997-2010 / MK 1, Ys3e) To be able to replace the starter motor of the Saab 9 5 you have to go to open the hood and access the components below, as the starter motor is loca…

Other guides you may be interested in

How to Replace the Timing Belt on a Chevrolet Matiz

How to replace the timing belt on a Chevrolet Matiz. Open the bonnet and secure it, lift the car on a column lift (if necessary, remove the front wheel using a screwdriver to take off the right wheel arch liner). Use a fixed spanner to loosen the tensioner pulley and slide the belt off its seat. Use a socket spanner to undo the securing bolt of the tensioner pulley, then remove the water pump as shown in the video. Fit the new water pump, the tensioner, and the belt itself, tightening everything with the socket spanner. Finally, refit the rivets along with the wheel arch liner and reattach the wheel with the tyre to the vehicle.

Watch the video!


by ScegliAuto

More videos