Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sherco Sef 300
Part: Clutch

In order to replace the clutch of the Sherco SEF 300, you need to loosen the screws that secure the clutch cover, located on the right side of the motorcycle: once the screws are loosened, you can proceed by locating the clutch discs underneath. The clutch must be removed from its housing and the discs that make it up must be extracted, so that the new replacement parts can be inserted; after the replacement, you can close the clutch cover, so that the new replacement part can be inserted, then cover everything with the cover.

Posted on 6 September 2024 by ScegliAuto

Video tutorial

Related tutorials

How to replace the clutch lever on the Sherco SEF 300?
How to replace the clutch lever on the Sherco SEF 300?
Sef 300 To replace the clutch lever on the Sherco SEF 300, you need to loosen the screws that secure the lever to its housing on the left side of the handleb…
How do you replace the clutch of the Sherco SEF 300?
How do you replace the clutch of the Sherco SEF 300?
Sef 300 It will be possible to replace the clutch of the Sherco SEF 300 by loosening the screws that secure the protective cover of the mechanism: this will …
How to Replace the Starter Motor on a Sherco SEF 300?
How to Replace the Starter Motor on a Sherco SEF 300?
Sef 300 To replace the starter motor on a Sherco SEF 300, locate this component, which is found at the lower front part of the frame. Once located, loosen th…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos