Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the engine oil of a Sherco ST300?

Model: Sherco Sherco 300
Part: Engine oil

Video tutorial

To change the oil of a Sherco ST300 engine, start by placing the motorcycle on a stand to make it stable. Then, locate the oil drain plug on the engine crankcase and the oil fill plug on the side of the engine.

Place a collection container under the drain plug and use a wrench to loosen the plug. Let the used oil drain completely.

After draining the oil, remove and check the oil filter. Replace it if necessary.

Lubricate the gasket of the new filter with new oil and install it. Tighten the drain plug to the correct torque. Pour the new oil into the engine through the fill plug, using the recommended oil in the owner's manual.

Check the oil level with the dipstick and add oil if necessary. Clean any oil residue and close the fill plug.

Start the engine and let it run for a few minutes to allow the new lubrication to circulate. Check the oil level again and add if necessary.

Make sure to properly dispose of the used oil at an authorized collection point.


Posted on 30 December 2024 by ScegliAuto


Related tutorials

How to Change the Engine Oil of a Sherco 300?
How to Change the Engine Oil of a Sherco 300?
Sherco 300 To replace the engine oil of a Sherco 300, start by positioning the bike on a flat surface and lifting it onto a stand. Next, remove the oil filler c…
How to Replace the Spark Plug on a Sherco 300?
Sherco 300 Today, focus on replacing the spark plug on your Sherco 300. First, carefully remove the seat and side panels of the bike to access the engine. Once …
How do you disassemble the engine of the Sherco 300?
How do you disassemble the engine of the Sherco 300?
Sherco 300 In order to disassemble the Sherco 300 engine, you need to loosen the screws that fix it to the housing in the center of the frame, also disconnectin…

How to Replace the Headlight Bulb on the MV Agusta Brutale 800RR?

To replace the headlight on the MV Agusta Brutale 800, you need to loosen the screws that secure the corresponding optical unit: these screws will be located on the sides and underneath the headlight. Once the screws are removed, you can extract the optical unit from its housing and disconnect the connector located inside; at this point, you can remove the bulb inside so that you can insert the new one. The headlight can now be secured with the appropriate screws to ensure everything functions correctly.

Watch the video!


by ScegliAuto

More videos