|
Do it yourself
| |||
| ||||
Model: Sherco Ty 125
To replace the exhaust on the Sherco TY 125, loosen the screws securing the clamp that connects the exhaust to the rest of the exhaust system. Once the clamp is removed, you can unscrew the bolt that secures the exhaust to the upper support, completely removing it. At this point, position the new exhaust: it should be connected to the rest of the exhaust system via the clamp and secured to the upper support with the appropriate bolt.
Updated on 12 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Ty 125
To replace the exhaust silencer on a Sherco TY 125, loosen the screws that secure the silencer to its housing. This will allow you to completely deta…
Ty 125
To replace the exhaust pipe of the Sherco TY 125, loosen the old pipe by unscrewing the bolts at the front of the bike near the engine. Once these pi…
Ty 125
To replace the seat on the Sherco TY 125, loosen the screws that secure the panel located at the front of the bike, between the seat and the handleba…
|
How to Service the Piaggio Vespa GTS 300
This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
