Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the exhaust on a Sherco 300, remove the right side panel, under which is the support for the upper part of the exhaust. Once the side panel is removed, unscrew the bolt of the upper support and then open the clamp that connects the exhaust to the exhaust pipe. Once the old exhaust is freed, you can completely remove it to replace it with a new one. After installation, reattach the side panel.

Updated on 14 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to change the motor oil of a Sherco 300?
How to change the motor oil of a Sherco 300?
Sherco 300 To replace the engine oil of a Sherco 300, start by placing the motorcycle on a flat surface and lifting it on a stand. Then, proceed by removing the…
How to Replace the Carburettor on the Sherco 300?
How to Replace the Carburettor on the Sherco 300?
Sherco 300 To replace the carburettor on the Sherco 300, loosen the screws securing the seat and the side panels located on both sides of the bike, just below t…
How to Replace the Rear Shock Absorber on the Sherco 300?
How to Replace the Rear Shock Absorber on the Sherco 300?
Sherco 300 To replace the rear shock absorber on the Sherco 300, completely remove the rear wheel of the bike by loosening the bolts that secure the wheel's cen…

How to replace the coolant in the BMW S1000 R

Today, we will see in this video tutorial how to bleed and replace the coolant in the BMW S1000 R motorcycle. First, place your motorcycle on a stand and start unscrewing the bleed screw located on the water pump casing, found at the bottom right; let the fluid drain into a container for about ten minutes. Now, unscrew the radiator cap and top up with the new coolant, the correct type for your radiator; fill it to the maximum level mark, starting the engine to circulate the fluid!

Watch the video!


by ScegliAuto

More videos