Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Resetting the Suzuki Access 125 Service Indicator Light

Model: Suzuki Access 125
Part: Service warning light

Video tutorial

To remind us to replace the engine oil of the Suzuki Access 125, a message "Oil" with a wrench appears at the top of the display. Once the necessary operations have been completed, we proceed to reset the notification system.

With the ignition off, press and hold the "Sel" button at the top left of the display, turn the key to start the instrumentation; after the check is complete, release the button and press it again for a few seconds. Press again for two seconds and after releasing it briefly press the "Mode" button, turn off the ignition to complete the reset.


Posted on 10 September 2025 by ScegliAuto


Related tutorials

How to reset the oil indicator on the Suzuki Access 125
How to reset the oil indicator on the Suzuki Access 125
Access 125 After performing the oil change and replacing the oil filter, it is necessary to reset the oil light in order to set the kilometers until the next se…
Resetting the service light on a Suzuki Access 125 BS6
Resetting the service light on a Suzuki Access 125 BS6
Access 125 After completing the kilometers required by the maintenance plan for the replacement of the engine oil of the Suzuki Access 125, a message appears on…
How to Reset the Service on the Suzuki Access 125 Scooter?
How to Reset the Service on the Suzuki Access 125 Scooter?
Access 125 In this tutorial, see how to reset the service on the Suzuki Access 125 scooter, a very simple and quick operation to perform only after completing a…

How to Replace the USB Socket on the Benelli TRK 502?

To replace the USB socket on the Benelli TRK 502, loosen the screws securing the left side panel of the motorcycle, located just below the handlebars: once this panel is freed, you can remove it and locate the USB socket connector. By disconnecting this connector, you can pull the socket out of its housing: then connect the new socket to the connector, inserting it into its housing. After installation, check that the socket works by reinstalling the panel.

Watch the video!


by ScegliAuto

More videos