Do it yourself
Frequently asked questions about cars and motorcycles
To remove the windscreen of the Sym MaxSym 600i, first remove the screws located underneath the plastic front panel, directly below the windscreen. Once this plastic part is removed, use a socket spanner to loosen the bolts securing the windscreen. After loosening, the windscreen must be disengaged and can be completely removed. At this point, it can be replaced with a new spare part, which should be securely fastened with all the bolts and the plastic front panel reattached.

Updated on 21 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Maxsym 600 To remove the windscreen of the Sym MaxSYM 600i, you need to loosen the bolts located at the bottom of the windscreen, behind the plastic cover. This…
Maxsym 600 To replace the belt on the Sym MaxSym 600, you need to loosen the bolts securing the cover near the rear wheel on the left side of the bike. Once the…
Maxsym 600 To replace the spark plug on the Sym MaxSym 600, lift the seat to access the under-seat compartment. Remove the plastic cover by unscrewing the screw…

How to Replace the Engine Cover on a Honda CB 650R

This guide provides instructions for removing and replacing the engine cover on a Honda CB 650R motorcycle, following these simple steps. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. Then, unscrew all the screws from the cover or engine casing found on the right, as shown in the video. At this point, install the new cover, ensuring to replace the gasket and clean the base thoroughly.

Watch the video!


by ScegliAuto

More videos