|
Do it yourself
| |||
| ||||
How to replace the coolant in the Sym GTS 300i
Model: Sym Gts 300i
Video tutorial
In this guide, we will see the instructions that will allow you to replace the coolant in the Sym GTS 300i scooter. First, place your scooter on the centre stand and start removing the plastic panel to access the cap of the coolant reservoir; then disconnect the coolant hose, allowing it to drain into a container for about ten minutes, as shown in the video. At this point, pour the new radiator fluid until it reaches the maximum level mark on the reservoir!
Updated on 28 July 2026 by ScegliAuto
Related tutorials
Gts 300i
This guide will show you the steps to replace the coolant in the Sym GTS 300i scooter. First, place your scooter on the centre stand and remove the p…
Gts 300i
To replace the air filter on a Sym GTS 300i, loosen the screws securing the cover of the casing near the rear wheel, just above the transmission. Onc…
Gts 300i
Change the engine air filter on a Sym Gts 300i scooter. Follow this guide to proceed with the change. Position the scooter on the centre stand. Using…
|
How to replace the piston on a Derbi Senda 125?
To replace the piston on a Derbi Senda 125, completely remove the seat and take off all parts above the engine block. Next, disconnect the connectors and unscrew the bolts securing the cylinder to the top of the block, locating the piston inside. Remove the old piston from its connecting rod by loosening the retaining ring, and replace it with a new spare part. Finally, reassemble all the components that were removed earlier. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.111
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |