Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The air filter should be cleaned periodically based on the usage of the bike: for motard use primarily on the road or possibly on track (without off-road), it should be done every 30-35 hours; for cross/enduro use, it is advisable to clean it after every off-road outing where the filter gets significantly dirty. Using a 5mm Allen key, remove the screws securing the side panels, as shown in the video. Unscrew the long screw holding the air filter and its small cover. Remove the screw with the washer and wash the filter multiple times with water and degreaser. Reassemble everything by proceeding in reverse order.

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the air filter of the TM Racing 125?
How do you replace the air filter of the TM Racing 125?
Tm Racing 125 In order to replace the air filter of the TM Racing 125, you will need to loosen the screws that secure the side panels of the bike located immediate…
How to Start the Tm Racing 125
How to Start the Tm Racing 125
Tm Racing 125 In this video tutorial, you will see instructions on how to start the Tm Racing 125 two-stroke, but the same procedure applies to all other two-strok…
How to Replace the Piston on a TM Racing 125
How to Replace the Piston on a TM Racing 125
Tm Racing 125 In this guide, we will see the instructions on how to disassemble and replace the piston and the entire cylinder assembly of the TM Racing 125. First…

How to Replace the Front Headlight on the Husqvarna 701?

In this tutorial, you will see how to replace the front headlight on the Husqvarna 701, a very simple and quick operation. First, ensure that the key is not inserted, then position yourself in front of the motorcycle, locate the four bolts on either side of the headlamp, and unscrew them using a Torx T30 key. Next, pull the entire assembly towards you, separate it from the support, and disconnect the power connector. At this point, you can separate the headlight from the panel, position the replacement, and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos