Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the fork of the TM Racing 125, you need to loosen the screws that fix the front wheel of the motorcycle to its housing, so that it can be completely detached: once the wheel has been freed, you will need to unscrew the screws that also fix the corresponding brake caliper. At this point it will be possible to remove it completely and proceed by loosening the screws that fix the fork to the steering, from the top: when these screws have been loosened, it will be possible to completely detach the old fork, inserting the new replacement piece.

Posted on 5 June 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the TM Racing 125?
How do you replace the exhaust pipe of the TM Racing 125?
Tm Racing 125 To replace the exhaust of the TM Racing 125, you need to loosen the screws that secure the side panel of the rear fender: once this panel is removed,…
How do you replace the brake pads of the TM Racing 125?
How do you replace the brake pads of the TM Racing 125?
Tm Racing 125 To replace the brake pads of the TM Racing 125, you need to perform the same operation for both the front wheel and the rear wheel: once the correspo…
How do you replace the piston of the TM Racing 125?
How do you replace the piston of the TM Racing 125?
Tm Racing 125 In order to replace the piston of the TM Racing 125, you will need to loosen the screws that secure the engine block to its housing, which is located…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos