Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the rear taillight of the Toyota RAV 4

Model: Toyota Rav 4 MK 3, Xa30 - Years 2006-2013
Part: Tail light

Today we will discover the steps that will allow us to disassemble and replace the rear taillight and its bulbs of the Toyota RAV 4. First, we open the rear door of the trunk and start removing the plastic side cover; then we unscrew the fixing screws of the taillight and disconnect the electrical connectors of the lights to remove it, as shown in the video. At this point, if necessary, we replace only the stop bulbs or the entire taillight, fixing it correctly and making the connection; finally, we check the operation of all the bulbs of the rear taillight!

Posted on 2 December 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Reflectors on a Toyota RAV 4
How to Replace the Rear Reflectors on a Toyota RAV 4
Toyota Rav 4 (2006-2013 / MK 3, Xa30) To replace the rear reflectors on a Toyota RAV 4, lift the vehicle to access the inside of the rear bumper. There will be two screws securing the ref…
How to disassemble the rear light of the Toyota RAV 4
How to disassemble the rear light of the Toyota RAV 4
Toyota Rav 4 (2019-2026 / Xa50, MK 5) Today's information will show us how to disassemble and replace the rear taillight and its bulbs of the Toyota RAV 4. First, we open the rear door of…
Replacement of the rear headlight bulbs of the Toyota RAV 4 MK2.
Replacement of the rear headlight bulbs of the Toyota RAV 4 MK2.
Toyota Rav 4 (2000-2006 / Xa20, MK 2) Let's see how to proceed to replace one of the rear light bulbs of the Toyota RAV 4, in case it burns out. We open the rear door of the car, remove t…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos