Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Bumper of the Toyota IQ?

Model: Toyota Iq MK 1 - Years: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Part: Rear bumper

Video tutorial

To remove the rear bumper of the Toyota IQ, open the boot and loosen the two bolts located at the corners of the seal surrounding the boot. Once these bolts are loosened, also unscrew the ones located at the bottom of the bumper.

The bumper can then be detached, and the connectors attached to its inner part must be disconnected. At this point, the bumper will be free, and you can replace it with a new spare part, which must be properly connected and secured.


Updated on 30 April 2026 by ScegliAuto


Related tutorials

How to Replace the Front Headlight Bulb on a Toyota IQ?
How to Replace the Front Headlight Bulb on a Toyota IQ?
Toyota Iq (2008-2015 / MK 1) To replace the front headlight bulb on a Toyota IQ, open the bonnet to access the components inside the engine bay. Specifically, detach the cover lo…
Where are the fuses located in the Toyota iQ?
Where are the fuses located in the Toyota iQ?
Toyota Iq (2008-2015 / MK 1) On the Toyota iQ, each of the fuse boxes is responsible for containing the fuses that regulate the operation of the devices installed on the vehicle.…
How to Replace the Remote Battery on a Toyota iQ
How to Replace the Remote Battery on a Toyota iQ
Toyota Iq (2008-2015 / MK 1) If the battery in your car's remote has run out, you can replace it by following the instructions and procedure outlined below, which will simplify t…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos