Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Bumper of a Toyota RAV4?

Model: Toyota Rav 4 Xa50, MK 5 - Years 2019-2026
Part: Rear bumper

To replace the rear bumper of the Toyota RAV4, first loosen the screws that secure the piece from its central lower part: once all these screws are loosened, proceed to loosen those inside the wheel arch. Now you can detach the external trim mouldings of the wheel arch and loosen the additional screws underneath: the bumper can then be detached, and the internal parking sensor connectors can be disconnected. You can then position the new bumper, securing it and connecting it to verify that everything works.

Posted on 31 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Bumper of the Toyota Rav 4?
How to Remove the Rear Bumper of the Toyota Rav 4?
Toyota Rav 4 (2000-2006 / Xa20, MK 2) To replace the rear bumper of the Toyota Rav 4, open the boot door and detach the fastening clips located inside. Next, remove the external cover of …
How to disassemble the rear bumper of the Toyota RAV 4
How to disassemble the rear bumper of the Toyota RAV 4
Toyota Rav 4 (2013-2018 / MK 4, Xa40) Below we will see the disassembly and replacement instructions for the rear bumper of the Toyota RAV 4, in simple and quick steps. First, open the re…
How to Replace the Rear Bumper on the Toyota RAV 4?
How to Replace the Rear Bumper on the Toyota RAV 4?
Toyota Rav 4 (2006-2013 / MK 3, Xa30) To remove the rear bumper from the Toyota RAV 4, you must first remove the fixing rivets located at the bottom of the bumper. Once removed, loosen th…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos