Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Rav 4
    4. : How to remove the rear bumper on a Toyota RAV4

Toyota Rav 4 - Video tutorial

Model: Toyota Rav 4 Xa30, MK 3 - Years 2006-2013
Part: Rear bumper
Operation: How to remove the rear bumper on a Toyota RAV4

Open the tailgate of the luggage compartment. Release the fastening clips located inside the luggage compartment. Remove the outer cover of the spare wheel, if present, and detach all the rivets located underneath it. At the bottom of the bumper, remove the caps and unscrew the screws. Unlock the fasteners in the side flaps of the bumper (pulling the corners towards you) and under the rear lights. Unlock the two latches in the trunk opening (pulling towards you). With the help of an assistant, pull back the bumper to remove it (make sure to check for any cables connected to the bumper).


Posted on 5 May 2024 by ScegliAuto

    Frequently Asked Questions

    • Rav 4 2013-2018 - How much does it cost to replace the rear bumper of a 2018 Toyota RAV4? Read Answer
    • Rav 4 2019-2026 - How to remove the rear bumper from Toyota RAV 4? Read Answer
    • Rav 4 2013-2018 - How much does it cost to replace the Toyota Rav 4 bumper? Read Answer
    • Rav 4 2006-2013 - How much does it cost to replace the rear bumper of the Toyota Rav4? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos