Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the roof seal on the Toyota Yaris

Model: Toyota Corolla MK 3 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013

See other generations:
Video tutorial

In this video tutorial, you will see the steps to remove and replace the roof seals on the Toyota Yaris. First, obtain a thin lever to gently detach the seal without damaging the roof; start from one end and remove it completely from the roof, as shown in the video.

Next, perform the same operation on the other seal; then clean the area thoroughly and install the new seals suitable for your model, securing them properly by applying the reverse procedure!


Updated on 27 September 2026 by ScegliAuto


Related tutorials

How to Replace the Side Window Seal on a Toyota Corolla
How to Replace the Side Window Seal on a Toyota Corolla
Toyota Corolla (2006-2013 / MK 3) To replace the side window seal on a Toyota Corolla, lever the seal from its outer side using a tool. This will allow you to lift the seal and spray …
How to Remove the Headlining in a Toyota Corolla?
How to Remove the Headlining in a Toyota Corolla?
Toyota Corolla (2019-2026 / MK 5, E210) In this tutorial, see how to remove the headlining in a Toyota Corolla, an extremely simple and quick operation. First, go inside the cabin, then rem…
How to Replace the Headlining on a Toyota Corolla
How to Replace the Headlining on a Toyota Corolla
Toyota Corolla (2000-2007 / MK 2) To remove the headlining on a Toyota Corolla, you must first disassemble all components that prevent its removal: these include the interior rear-vie…

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos