Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
This is an advanced modification, suitable for more experienced users. Use the mount at the centre of the frame to secure the support for your controls. Remove the brake pump and create a sturdy iron plate as the base of the supporting structure. Finish this as you prefer, using welded iron rods. Relocate the brake pump so it does not interfere with your new structure and modify the pin that operates the piston of the pump if necessary. Also, move the brake fluid reservoir. Use your creativity to decide what else to relocate or modify to accommodate the new structure. Install your advanced controls in place of the standard controls as shown in the video. Good luck!

Updated on 30 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery on a Triumph Bonneville
How to Replace the Battery on a Triumph Bonneville
Bonneville Today, we will see how to remove and replace the battery on a Triumph Bonneville motorcycle, following the instructions below. First, remove the seat…
How to Replace the Battery on a Triumph Bonneville Bobber?
How to Replace the Battery on a Triumph Bonneville Bobber?
Bonneville To replace the battery on a Triumph Bonneville Bobber, you need to loosen the screws that secure the cover located on the right side of the bike, jus…
How to Remove the Exhaust Silencer and Rear Wheel on Triumph Bonneville
How to Remove the Exhaust Silencer and Rear Wheel on Triumph Bonneville
Bonneville In this video tutorial, you will see how to remove the exhaust silencer and the rear wheel on a Triumph Bonneville in simple and quick steps. First, …

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos