Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Fuel Tank on the Triumph Street Triple R?

Model: Triumph Street Triple R
Part:

Video tutorial

In this tutorial, see how to remove the fuel tank on the Triumph Street Triple R, a very simple and quick operation. First, remove the seat.

Then, using an 8 mm socket spanner, undo the lower bolt of the tank and extract the pin. Next, undo the two front screws, move any cables that may obstruct, and lift the tank. At this point, extract all the hoses located at the rear, disconnect them, and drain any remaining fuel.

To fit the replacement part, simply follow the reverse procedure.


Updated on 1 July 2026 by ScegliAuto


Related tutorials

How to Replace the Air Filter on the Triumph Street Triple R
How to Replace the Air Filter on the Triumph Street Triple R
Street Triple R In today's tutorial, you will see the steps to remove and replace the engine air filter on the Triumph Street Triple R motorcycle. First, place your …
How to Remove the Rear Wheel of the Triumph Street Triple
How to Remove the Rear Wheel of the Triumph Street Triple
Street Triple R This guide provides instructions for removing and replacing the rear wheel or tyre of the Triumph Street Triple. First, place the rear stand to lift …
How to Replace the Air Filter on the Triumph Speed Triple RS?
How to Replace the Air Filter on the Triumph Speed Triple RS?
Street Triple R To replace the air filter on the Triumph Speed Triple RS, loosen the screws securing the fuel tank to its housing. Once the tank screws are loosened,…

Replacing the Front Brake Pads on the Triumph Daytona 675

The following instructions will allow you to remove and replace the front brake pads on the Triumph Daytona 675. First, place the bike on a stand and begin undoing the fixing screws of the front brake caliper; apply pressure to the caliper piston to retract it, thus removing the old brake pads, as shown in the video. At this point, clean the caliper of any residual dirt, then install the new original brake pads; reattach the caliper to the disc, replacing the other brake pads in the same manner!

Watch the video!


by ScegliAuto

More videos