Do it yourself
Frequently asked questions about cars and motorcycles

How to adjust the handbrake on a Volkswagen Polo

Model: Volkswagen Polo MK IV, Polo IV, Polo 4, MK 4, 9N - Years 2001-2009
Part: Fuse box

In this brief guide, you will see how to adjust the handbrake on a Volkswagen Polo. First, get inside the cabin and start by removing the centre tunnel by unscrewing the fixing screws; underneath, you will find the adjustment for the handbrake cable, tightening it to pull the cable, as shown in the video. To ensure the adjustment is done correctly, the rear brake shoes must be in good condition; perform several tests until you achieve the optimal result, then reassemble the centre tunnel.

Posted on 9 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) To adjust the handbrake on the Volkswagen Polo, first lift the car using a jack. Once the car is off the ground, remove the left rear wheel and take …
Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) To adjust the handbrake of the Volkswagen Polo, lift the part of the centre tunnel located immediately behind the base of the handbrake lever. Once t…
Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) Today, you will learn the steps to adjust the handbrake on the Volkswagen Polo. Before adjusting the handbrake, check the wear condition of the rear …

    Frequently Asked Questions

    • Polo 2017-2025 - What is the location of the power steering fuse on the Volkswagen Polo? Read answer
    • Polo 2009-2017 - Where is the wiper fuse located in the Volkswagen Polo? Read answer
    • Polo 2017-2025 - Where is the Volkswagen Polo wiper relay located? Read answer

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos