Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Antenna of the Volkswagen Golf

Model: Volkswagen Golf Golf VII, MK 7, Golf 7 - Years 2012-2019
Part: Antenna

Today, we will go through the main instructions to remove and replace the radio antenna of the Volkswagen Golf. First, open the vehicle's bonnet and begin removing the roof lining, prying it gently at the edges (without damaging it); this will give you access to the inside of the antenna, as illustrated in the video. At this point, unscrew the antenna nut and disconnect its electrical connector, pulling it out from the outside along with its base. Replace it with the new one and reassemble everything, checking the radio's functionality.

Posted on 10 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to install the shark fin antenna on a Volkswagen Golf 4
How to install the shark fin antenna on a Volkswagen Golf 4
Volkswagen Golf (1997-2003 / Golf IV, MK 4, Golf 4) Installing the shark fin antenna on a Volkswagen Golf MK 4 is a simple and quick operation that can be done independently. The antenna can be purchas…
How to Replace the Antenna on a Volkswagen Golf?
How to Replace the Antenna on a Volkswagen Golf?
Volkswagen Golf (1997-2003 / Golf IV, MK 4, Golf 4) To replace the antenna on a Volkswagen Golf, you need to remove the headlining in the rear section of the car, where the antenna housing is located: …
How to Remove the Radio Antenna from Golf 6
How to Remove the Radio Antenna from Golf 6
Volkswagen Golf (2008-2012 / MK 6, Golf VI, Golf 6, 5K1) Is the antenna on your car damaged? This guide shows how to remove the antenna from the roof of the Golf 6. Lift the tailgate and remove the cover tr…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos