Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to reset the Volkswagen Polo service

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo III, Polo 3, MK III, 6N, MK 3 - Years 1994-2003
Part: -board computer
Operation: How to reset the Volkswagen Polo service

To reset the Volkswagen Polo service proceed as follows: start by turning on the instrument panel, the message: service oil" flashes, turn off the instrument panel, hold down the button below the total km display until dashes appear on the display and finally "km 0.0" appear. After this operation we can turn on the instrument panel, turn it off, turn it on again and then finally turn on the car engine and wait a few minutes with the engine running at idle speed. After a few minutes we can turn off the engine We turn on the instrument panel and notice that the wording "service oil" no longer appears, the procedure is complete.


Posted on 27 November 2022 by ScegliAuto

    Frequently Asked Questions

    • Polo 2009-2017 - What does the engine malfunction warning light on the Volkswagen Polo mean? Read Answer
    • Polo 2017-2025 - What to do if voice control on the Volkswagen Polo is not available? Read Answer
    • Polo 2017-2025 - Why does the center display of the Volkswagen Polo 6 not work? Read Answer
    • Polo 2009-2017 - How to reset the tire warning light in a Wolksvagen Polo? Read Answer
    • Polo 2009-2017 - What does the Volkswagen Polo "Insp" light mean? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos