Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Fz
Part: Oil filter

Before changing the oil, start the engine for a few minutes to warm up the circulating oil and facilitate its subsequent drainage. Position a container under the engine bay and remove the drain bolt clearly shown in the video. Collect the used oil and dispose of it properly at recycling centres. While the oil drains, remove the three bolts securing the oil filter cover and replace the filter, lubricating the O-ring. Refit the drain bolt and refill through the top hole with the same amount of lubricant that was drained.

Updated on 15 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Engine Oil and Oil Filter Replacement for Yamaha Virago 250
Engine Oil and Oil Filter Replacement for Yamaha Virago 250
Xv 250 Engine oil and oil filter replacement for a Yamaha Virago 250cc. Position the bike on the side stand. Place a container for disposing of the oil unde…
Engine Oil and Filter Change for a Yamaha YFZ450
Engine Oil and Filter Change for a Yamaha YFZ450
Yfz450f Descriptive guide for changing the engine oil and oil filter of a Yamaha YFZ450. Obtain 2L of Motul 5100 SAE 10W40 oil and an Hiflo HF140 filter. Pla…
Engine Oil and Oil Filter Replacement on Yamaha FZ6 - FZ6 Fazer
Engine Oil and Oil Filter Replacement on Yamaha FZ6 - FZ6 Fazer
Fz6 In today’s tutorial, see how to replace the engine oil and oil filter while performing routine maintenance on a Yamaha FZ6 and FZ6 Fazer. First, posi…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos