Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha T Max 530
Part: Battery

In today's video, you will see a very interesting operation that can be performed on your Yamaha T-Max. Specifically, how to connect the cables to recharge the service battery. It can happen that you get stranded and cannot start your vehicle. Therefore, it is advisable to follow the guide to the end. First, park the vehicle on a level surface. Then, remove the ignition key. Proceed by detaching the lower plastic frame and then you can remove the left cover. At this point, you can access the compartment in question and recharge your battery.

Updated on 9 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Battery on Yamaha T-Max 530
Replacing Battery on Yamaha T-Max 530
T Max 530 In this video, let's see how to remove and replace the battery on a Yamaha T-Max 530, following these simple steps. First, lift the seat and unscrew …
How to Change the Remote Battery on a Yamaha T-Max 530
How to Change the Remote Battery on a Yamaha T-Max 530
T Max 530 In this video, you will learn how to change the battery in the remote of a Yamaha T-Max 530: you will need a small, thin flathead screwdriver and a n…
How to replace the battery of the Yamaha T Max 530
How to replace the battery of the Yamaha T Max 530
T Max 530 Replacing the battery of the 2010 Yamaha T Max 530 scooter is a very simple operation to perform thanks to our guide that will allow you to carry out…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos