Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Fairings from a Yamaha YZF R1

Model: Yamaha Yzf R1
Part:

Video tutorial

This guide outlines the steps to remove and replace the fairings on a Yamaha YZF R1. First, place your bike on a stand and start by removing the fairings located under the engine and on the sides by unscrewing the screws found on the sides; then detach the fairings located next to the headlamp, as shown in the video.

At this point, also remove the two fairings located near the front brake discs by unscrewing the two screws; then remove the windscreen and the rear fairings, proceeding in the same manner, following the video tutorial until the end!


Updated on 28 July 2026 by ScegliAuto


Related tutorials

How to Replace the Clutch on the Yamaha YZF-R1
How to Replace the Clutch on the Yamaha YZF-R1
Yzf R1 You can replace the clutch on the Yamaha YZF-R1 by loosening the screws that secure the transmission cover located on the right side of the motorcycl…
How do you replace the exhaust pipe of the Yamaha YZF-R1?
How do you replace the exhaust pipe of the Yamaha YZF-R1?
Yzf R1 It will be possible to replace the muffler that is installed at the rear wheel of the Yamaha YZF-R1 by loosening the screws that fix it to the corres…
How to Dismantle the Engine of a Yamaha YZF R1
How to Dismantle the Engine of a Yamaha YZF R1
Yzf R1 To remove the engine from the Yamaha YZF R1, you need to loosen the screws that secure the engine block protection panels and those that fix the engi…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos