Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Aprilia Sr 50
Part:

This guide provides instructions on how to remove and replace the front fairing of the Aprilia SR 50 scooter, following these simple steps. First, place your scooter on the centre stand and start by unscrewing all the fixing screws located at the rear of the fairing, under the instrument panel; then unscrew the screws on the front grille and the sides, also unscrewing the additional screws located on the front wheel arch, as shown in the video. At this point, gently remove the fairing by disconnecting the wiring at the back; then refit everything!

Updated on 21 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Clutch from an Aprilia SR 50
How to Remove the Clutch from an Aprilia SR 50
Sr 50 Today, we will see in this video tutorial how to remove and replace the clutch on the Aprilia SR 50 scooter by following these simple and quick steps…
How do you disassemble the engine of the Aprilia SR 50?
How do you disassemble the engine of the Aprilia SR 50?
Sr 50 The engine of the Aprilia SR 50 can be disassembled by loosening the screws that secure the block to its housing in the center of the frame: once the…
How to Reset the "Service" Light on an Aprilia SR 50
How to Reset the "Service" Light on an Aprilia SR 50
Sr 50 Before you begin, sit on the seat of your Aprilia SR 50. Start by turning the key in the ignition switch to activate the instrument panel. Next, pres…

How to replace the air filter in the Herald Classic 125?

In this tutorial, you will see how to replace the air filter in the Herald Classic 125, a very simple and quick operation. First, position yourself on the left side of the motorcycle, then grab the panel located under the seat, pull it towards you, and detach it from the frame. Next, unscrew the three fastening screws of the airbox cover, remove it, and take out the old filter from its housing. At this point, remove any dirt residue present, insert the replacement filter, and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos