Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. Tt
    4. : Rear light bulb

Audi Tt - Rear light bulb

Audi Tt (1998-2006 / 8N, MK 1)
Replacement of the rear headlight bulbs of the Audi TT.
Below we will see the instructions that will allow us to disassemble and replace the rear headlight bulbs of the Audi TT, in simple steps. First, we open the …read all…
Posted on 23 October 2023 by ScegliAuto
Audi Tt (1998-2006 / 8N, MK 1)
How to replace reverse light bulbs in Audi TT?
In this tutorial we can see how to replace the reverse light bulbs in your Audi TT, a very simple and fast operation. Before proceeding, make sure that the key …read all…
Posted on 28 November 2022 by ScegliAuto
Audi Tt (1998-2006 / 8N, MK 1)
Replacement rear bulbs on Audi Tt
Open the door of the small trunk and look sideways inside it: you will notice that inside the frame there are two doors (one on each side). Open them using a …read all…
Posted on 7 January 2024 by ScegliAuto
Airbags (1) Alternator (3) Shock absorbers (1) Car stereo (3) Battery (1) Air Vents (1) Arm (1) Gearbox (2) Spark plugs (1) Bodywork (3) Key (2) -board computer (2) Checks and maintenance (14) Throttle body (1) Dashboard (1) Headlight (4) Tail light (4) Air filter (1) Grille (3) Headlight bulb (1) Rear light bulb (3) Antifreeze liquid (1) Dashboard light (1) Third brake light (1) Muffler (2) Door panel (3) Front bumper (3) Rear bumper (1) Brake pads (3) Tires (1) Fuel pump (2) Push button (1) Window lift button (1) Instrument cluster (4) Fuse box (11) Drive shaft (1) Coolant temperature sensor (1) Suspensions (2) Outside rearview mirror (3) Windscreen wipers (1) Engine head (1) Turbine (3) Steering wheel (1)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos