Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the third brake light on the Audi A6 C7 version

Model: Audi A6 C7, MK 4 - Years 2011-2018
Part:

In this video, we can see how to disassemble the third brake light on the Audi A6 C7 sedan and station wagon. For the sedan, this light is located inside the rear window, and as we can see from the illustrations shown by the YouTuber, it is enough to gently remove it from its connectors to remove the entire light fixture. As for the station wagon, the third brake light is attached to the spoiler, so the spoiler itself must be removed; to do this, four screws and pressure clips need to be removed. Once the spoiler is removed, there are three screws to remove to disassemble the third brake light from the spoiler; then we will need to loosen the seals, lift the tab, and remove the light fixture.

Posted on 4 November 2024 by ScegliAuto

Video tutorial

Related tutorials

Removing and Replacing the Third Brake Light of an Audi A6
Removing and Replacing the Third Brake Light of an Audi A6
Audi A6 (2004-2012 / MK 3, C6) Let’s briefly go over the instructions that will allow you to remove and replace the third brake light and its bulbs on an Audi A6. First, open the r…
How to Remove the Third Brake Light and Its Bulbs on an Audi A6
How to Remove the Third Brake Light and Its Bulbs on an Audi A6
Audi A6 (1997-2004 / MK 2, C5) These simple steps will allow you to remove the third brake light assembly and replace its bulbs on an Audi A6. First, open the trunk of the vehicle …
How to replace the third brake light bulb of the Audi A6
How to replace the third brake light bulb of the Audi A6
Audi A6 (2004-2012 / MK 3, C6) Today we will see the instructions that will allow us to disassemble and replace the third brake light bulbs of the Audi A6. First, we open the rear …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos