Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the accelerator pedal of the Audi Q3.

Model: Audi Q3 8U - Years 2011-2018
Part: Accelerator

The instructions provided in this guide will illustrate the procedure for disassembling and replacing the accelerator pedal of the Audi Q3. First, let's open the driver's side front door and begin detaching the accelerator pedal from the bottom by releasing the plastic clip using a thin, pointed tool. Then, disconnect the electrical connector of the potentiometer located on the back of the pedal, as shown in the video. At this point, we will install the new accelerator pedal, connecting it and securing it properly to the floor.

Posted on 6 December 2025 by ScegliAuto

Video tutorial

Related tutorials

How to disassemble the throttle body of the Audi Q3 2.0 TDI
How to disassemble the throttle body of the Audi Q3 2.0 TDI
Audi Q3 (2011-2018 / 8U) The instructions in this guide will show us how to disassemble and replace the throttle body of the Audi Q3 2.0 TDI, in simple steps. First, we open …
How to disassemble and replace the rear headlight of the Audi Q3
How to disassemble and replace the rear headlight of the Audi Q3
Audi Q3 (2011-2018 / 8U) Below we will see the instructions that will allow us to disassemble and replace the rear taillight of the Audi Q3, in simple steps. First, we open t…
Where is the throttle valve position sensor located on the Audi Q3?
Where is the throttle valve position sensor located on the Audi Q3?
Audi Q3 (2011-2018 / 8U) In this video we see where the TPS position sensor is located on the Audi Q3: it is right on the throttle valve, connected to the end of the throttle…

How to Reset the Central Locking of the Volkswagen Golf 4?

If the central locking system of the Volkswagen Golf 4 is not working, it is likely necessary to reset the system: to do this, open the driver's door and detach the side panel of the dashboard next to the steering wheel. Under this panel, you will find the fuses, including the one for the central locking, which is indicated in the manual as number 14. To reset the system, remove this fuse from its housing, then reinsert it or replace it with a new one of the same amperage: this will reset the central locking system.

Watch the video!


by ScegliAuto

More videos