Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Replacing the Rear Brake Switch on the Audi A4

Model: Audi A4 B8 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016

See other generations:
Video tutorial

This guide outlines the main instructions on how to disassemble and replace the rear brake pedal switch on the Audi A4. First, open the driver's side front door and begin to disassemble and remove the brake pedal by unscrewing the mounting screws; the pedal switch is located above it, disconnecting the electrical connector to remove it. At this point, install the new stop switch, securing it properly; once connected, verify the correct operation of the stop light with the instrument panel on, then reassemble everything.


Posted on 16 April 2026 by ScegliAuto


Related tutorials

Replacing the Brake Pedal Switch on the Audi A4
Replacing the Brake Pedal Switch on the Audi A4
Audi A4 (2004-2008 / B7) Below are the instructions to remove and replace the rear brake pedal switch on the Audi A4. First, get inside the vehicle on the driver's side and s…
Guide to Disassembling the Camshaft of the Audi A4 2.0 TFSI
Guide to Disassembling the Camshaft of the Audi A4 2.0 TFSI
Audi A4 (2007-2016 / B8) In this guide, you will see the main steps for disassembling and replacing the camshaft of the Audi A4 2.0 TFSI. To disassemble the camshaft, you mus…
Guide to replacing the timing belt of the Audi A4 2.0 TDI
Guide to replacing the timing belt of the Audi A4 2.0 TDI
Audi A4 (2007-2016 / B8) The instructions in this guide will show us how to disassemble and replace the timing belt of the Audi A4 2.0 TDI. To access the timing belt, it is n…

    Frequently Asked Questions

    • A4 2004-2008 - How much does it cost to change ownership of an Audi A4 1.9 TDI? Read answer

How to Reset the Tyre Light on a Toyota Aygo?

To reset the tyre light on a Toyota Aygo, start by locating the reset button, which is found in the glove compartment of the front passenger side. Turn on the car and ensure that the tyres are at the correct pressure. Then, press and hold the reset button for a few seconds until the tyre light either flashes or turns off, depending on the model. Release the button and wait for the reset procedure to complete. Restart your Toyota Aygo and check if the tyre light has turned off, indicating that the reset was successful.

Watch the video!


by ScegliAuto

More videos