Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Steering Arm and Vibration Stop

Model: Audi A6 MK 2, C5 - Years 1997-2004
Part: Control arm

The necessary tools are a ratchet wrench, a set of open-end wrenches, and the replacement arm. Lift the vehicle and secure it with appropriate supports to prevent it from falling. Remove the wheel to access the mechanics. Once the broken arm is located, proceed to remove it by unscrewing all the bolts. Also remove the steering arm support by unscrewing the two bolts. Check the rest of the mechanics, especially the vibration stops that support the arms and bolts; replace them if necessary. Reassemble the new arm and the rest of the previously removed mechanics, lubricating the various components. Check the wheel alignment.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install the Cabin Air Filter
How to Install the Cabin Air Filter
Audi A6 (1994-1997 / C4, MK 1) Replacing the cabin air filter is a straightforward procedure that you can do yourself without needing help from a trusted mechanic. The following gu…
Replacing the Cabin Air Filter
Replacing the Cabin Air Filter
Audi A6 (2004-2012 / MK 3, C6) Changing the cabin air filter in your car is very important. The filter protects against external agents that enter the cabin. It is crucial to repla…
Cabin Air Filter Replacement
Cabin Air Filter Replacement
Audi A6 (1997-2004 / MK 2, C5) The cabin air filter is located just below the windshield on the passenger side. To access it, open the hood, remove the seal along the rear edge, an…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos