Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Stabilizer Bar Links on an Audi A4 B8

Model: Audi A4 B8 - Years 2007-2016
Part: Checks and maintenance

To change the stabilizer bar links on an Audi A4 B8, first, remove the bolts from the front wheel, then take it off and lift the vehicle, securely placing it on a jack stand. Clean the stabilizer bar mounting points with a wire brush, then spray some WD-40. Unscrew the fastening nut that connects the stabilizer bar link to the shock absorber fork, then unscrew the fasteners that connect the stabilizer bar link to the bar itself. Remove the transverse stabilizer brace. While you're at it, inspect the stabilizer support bushings. Replace them if necessary. Next, clean the mounting seats of the stabilizer bar link with a wire brush and WD-40. Now you're ready to install the new bar; tighten the fasteners, and also tighten the fastener that connects the stabilizer bar link to the shock absorber fork, then those that connect the stabilizer bar link to the bar itself. A nice spray of WD-40 is just what you need now. Spray some copper grease on the hub and then clean the brake rotor with brake cleaner. After a few minutes, you can reattach the wheel. Job done.

Updated on 1 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Audi A4 (2000-2004 / B6) Lift the vehicle on a hydraulic lift and remove the front wheels (pay attention to any anti-theft bolt); then disconnect the links from the suspensio…
Audi A4 (2000-2004 / B6) To comfortably replace the rear stabilizer link, lift the vehicle on a hydraulic lift and remove the rear wheel; then, unscrew the nut that secures t…
Audi A4 (2004-2008 / B7) In this video, we will see how to fix the noisy front end on an Audi A4. The problem is caused by rattling noises: creaks, sharp knocks, which are no…

Other guides you may be interested in

    Frequently Asked Questions

    • A4 2007-2016 - How does the navigation system of my Audi A4 work? Read answer
    • A4 2004-2008 - Where is the AUX cable socket on the Audi A4? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos