Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Stabilizer Bar Bushing Replacement

Model: Audi Q7 4L, MK 1 - Years 2006-2015
Part: Anti-roll bar

It is quite common for the support bushings of the stabilizer bar to break, but their replacement is very simple and economical; lift the vehicle on a lift and remove the mounting bolts of the stabilizer bar support bracket to take it off; then remove the connecting bolt of the bar to the suspension link so you can separate them and then lift the bar, remove the old bushing, and install the new one before reattaching the connecting bolt to the link and the support bracket.

Updated on 18 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace a Suspension Arm
How to Replace a Suspension Arm
Audi Q7 (2006-2015 / 4L, MK 1) A worn suspension arm must be replaced to avoid a dangerous loss of vehicle control. It is not a very complicated job and can be done alone, without …
Replacement of Rear Fog Light
Replacement of Rear Fog Light
Audi Q7 (2006-2015 / 4L, MK 1) The rear fog light is integrated into the bumper. To replace the bulb, you need to remove the light from its housing. First, remove the cap located j…
License Plate Light Bulb Replacement
License Plate Light Bulb Replacement
Audi Q7 (2006-2015 / 4L, MK 1) To replace the license plate light bulb, open the rear hood and hold it up to remove the screw securing the small light fixture that houses the bulb …

How to Replace the Fuel Pump on an Opel Corsa C

Usually, upon the first ignition of the dashboard, a sound similar to a spray can be heard from the rear of the cabin: this is the fuel pump pressurising the system and preparing to supply fuel to the engine for ignition; if this sound is not heard, start by checking the integrity of the relevant power fuse, and if it is intact, verify that voltage reaches the power connector; if current is present, you can also try powering the pump directly to confirm it is faulty; replacing it is very simple, just disconnect the connector and hoses, then unclip the retaining ring and remove it to replace it with a new one.

Watch the video!


by ScegliAuto

More videos