Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Third Brake Light Bulbs on the Audi A3

Model: Audi A3 MK 2, 8P - Years 2003-2013
Part: Light bulb

This short and simple guide will show you the main instructions on how to remove and replace the bulbs of the third brake light on the Audi A3. First, open the boot lid and start removing the plastic cover located behind the third brake light; then unscrew the fixing screws to detach and remove it from the exterior, as illustrated in the video. At this point, remove and replace any faulty bulbs of the third brake light, replacing the entire unit if necessary (disconnecting the electrical connector); apply the reverse procedure for reassembly!

Updated on 14 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the third brake light on the Audi A3
How to replace the third brake light on the Audi A3
Audi A3 (2012-2019 / 8V, MK 3) In this new mini guide of ours, we will help you to carry out the replacement of the third brake light of your Audi A3 quickly and correctly. First o…
How to Remove the Third Brake Light from an Audi A3?
How to Remove the Third Brake Light from an Audi A3?
Audi A3 (2003-2013 / MK 2, 8P) Removing the third brake light, located at the top of the tailgate, is fairly straightforward but requires care not to damage the pressure clips of t…
How to Replace the Third Brake Light Bulb on the Audi A3?
How to Replace the Third Brake Light Bulb on the Audi A3?
Audi A3 (2003-2013 / MK 2, 8P) To replace the third brake light bulb on the Audi A3, open the boot to access the inside of the rear hatch. Here, you will need to unscrew the two sc…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos