Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The oil change of the Benelli TRK 502 can be performed by loosening the drain plug located in the central lower part of the vehicle, allowing all the used oil to flow into a properly positioned container: once the drainage is complete, the oil filter, also located in the same position, can be removed and replaced with a new one. After the replacement, the oil level can be topped up by pouring the necessary amount of oil through the vent on the left side of the motorcycle: once the top-up is complete, the plug can be closed and everything should be checked to ensure proper functioning.

Posted on 28 September 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Perform an Oil Change on a Benelli TRK 502
How to Perform an Oil Change on a Benelli TRK 502
Trk 502 Let’s go through the procedure for performing routine maintenance by changing the engine oil and oil filter on a Benelli TRK 502. First, place the mo…
How to Change Engine Oil and Oil Filter on Benelli TRK 502
How to Change Engine Oil and Oil Filter on Benelli TRK 502
Trk 502 In this guide, learn how to change the engine oil and oil filter as part of regular maintenance on a Benelli TRK 502. First, position the motorcycle …
How to Perform Maintenance (Oil Change) on the Benelli TRK 502
How to Perform Maintenance (Oil Change) on the Benelli TRK 502
Trk 502 Today, in this video tutorial, you will learn how to carry out routine maintenance by replacing the engine oil and oil filter of the Benelli TRK 502 …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos