Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Position the motorcycle on the rear or front stand. Remove the caliper retaining bolt and take the caliper off the support. Use a screwdriver to detach the old pads from the rear brake caliper. Clean the brake caliper thoroughly with a brush. Fit the new pads onto the caliper; attach the caliper to the brake disc. Tighten all bolts and test the braking with the lever. Prepare to perform the same operations on the other calipers.

Updated on 9 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on Benelli TNT 600?
How to Replace the Front Brake Pads on Benelli TNT 600?
Tnt 600 To replace the front brake pads on the Benelli TNT 600, loosen the screws located at the top and bottom of the caliper. This will allow the caliper t…
How to Replace the Rev Sensor on a Benelli TNT 600
How to Replace the Rev Sensor on a Benelli TNT 600
Tnt 600 This guide provides instructions on how to remove and replace the engine rev sensor on a Benelli TNT 600 motorcycle by following these simple steps. …
How to Replace the Handlebars on a Benelli TNT 600
How to Replace the Handlebars on a Benelli TNT 600
Tnt 600 Follow these instructions to remove and replace the handlebars on your Benelli TNT 600 motorcycle. First, place the bike on a stand and start by remo…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos