Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil in the Benelli TNT 600?

Model: Benelli Tnt 600
Part: Engine oil

Video tutorial

In this tutorial, you will learn how to change the engine oil in the Benelli TNT 600, a very simple and quick operation that should be performed every 1,000 miles. First, ensure that the engine is completely cold for safety, then position a container underneath it, locate the drain bolt, and unscrew it with a socket spanner.

Allow all the oil in the system to drain out, unscrew the old filter, and tighten the replacement. At this point, simply reinsert the bolt and add the new oil through the designated hole.


Updated on 28 August 2026 by ScegliAuto


Related tutorials

How to change the engine oil on a Benelli TnT 600?
How to change the engine oil on a Benelli TnT 600?
Tnt 600 To change the engine oil on a Benelli TnT 600, loosen the drain plug of the oil sump, located at the central lower part of the bike: once this plug i…
How to Remove the Fuel Tank from the Benelli TNT 600
How to Remove the Fuel Tank from the Benelli TNT 600
Tnt 600 Below is the procedure to remove and replace the fuel tank on the Benelli TNT 600 motorcycle. First, place the bike on a stand and start by removing …
How to Replace the Chain and Sprocket on a Benelli TNT 600
How to Replace the Chain and Sprocket on a Benelli TNT 600
Tnt 600 These brief and simple steps will show you how to disassemble and replace the chain and sprocket on a Benelli TNT 600 motorcycle. First, place the mo…

How to Replace the Rear Brake Pads on a Derbi Senda 125?

To replace the rear brake pads on a Derbi Senda 125, loosen the nut that secures the central axle of the rear wheel so that it can be completely removed from its housing. Once the wheel is removed, you can slide out the pin that secures the pads inside the brake caliper and remove them from their housing. After the old pads have been removed, insert the new replacement parts, securing them with the pin. Finally, reinstall the rear wheel, positioning it at the end of the swingarm.

Watch the video!


by ScegliAuto

More videos