Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Grips on the Benelli TRK 502X?

Model: Benelli Trk 502
Part:

Video tutorial

To replace the grips on the Benelli TRK 502X, loosen the screws that secure the switchgear located on the sides of the handlebars, right near the base of the grips: once the screws under these switchgears are loosened, you can completely detach the switchgear from its housing to grasp the grip and slide it off completely from its housing.

At this point, you can insert the new grip into its place, reinsert the switchgear, and check that everything works.


Updated on 19 September 2026 by ScegliAuto


Related tutorials

Trk 502 To replace the tyres on a Benelli TRK 502X, loosen the nuts securing the wheel hubs, both front and rear: once these nuts are loosened, you can proce…
Trk 502 To replace the grips on a Benelli TRK 502, loosen the bolts located at the end of the grips: this will allow you to detach the handguard from the end…
Trk 502 To replace the rear brake pads of the Benelli TRK 502X, you need to loosen the screws that secure the corresponding caliper, so that it can be detach…

How to Assemble the Engine Block of the Husaberg FE 501

Here are the instructions to assemble the engine block of the Husaberg FE 501 enduro bike. First, assemble the engine transmission by installing the gear ratios and then the clutch assembly; after that, install the engine's thermal part by reassembling the crankshaft and then the cylinder head assembly (including piston, cylinder, and head), as shown in the video. At this point, install the stator and flywheel, as well as the electrical components of the engine, following the video tutorial to the end for reassembly!

Watch the video!


by ScegliAuto

More videos