Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Beta Rr 50

For illustrative purposes, we will see how to remove the rev limiter of the Beta RR 50 enduro motorcycle; remember not to keep the rev limiter removed, as this could cause irreparable damage to the engine. First, put the motorcycle on the stand and start by removing the seat; underneath, you will find the engine control unit, where you will disconnect the main wiring, as shown in the video. At this point, disconnect the rev limiter cable, as indicated in the manual, being careful not to damage the connector; finally, reconnect the rev limiter.

Posted on 22 September 2025 by ScegliAuto

Video tutorial

Related tutorials

Removing the Rev Limiter from a Beta RR 50
Removing the Rev Limiter from a Beta RR 50
Rr 50 In this video tutorial, learn how to remove the rev limiter from a Beta RR 50 in simple steps. First, take a flat screwdriver and unscrew the seat bo…
How to Disable the Rev Limiter on the Beta RR 50
How to Disable the Rev Limiter on the Beta RR 50
Rr 50 In today's tutorial, you will learn how to temporarily disable the rev limiter on the Beta RR 50 enduro bike by following the instructions below. Fir…
Adjusting the Carburetion on Beta RR 50
Rr 50 If your Beta is experiencing strange flat spots, especially uphill, it may be time to adjust the carburetion. To do this, remove the air filter manif…

Where is the Battery on the Piaggio Medley 125 Scooter and How to Remove It?

In this video, see where the battery is located on the Piaggio Medley 125 scooter and how to remove it, a very simple and quick operation. As shown, it is located behind the front storage compartment, positioned under the handlebars. To access it, first open the compartment, then remove the right cover by unscrewing the relevant screws with a cross-head screwdriver. Once done, unscrew the additional screws of the battery cover with a Torx T25 key, extract it, and disconnect both terminals with the same screwdriver. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos