|
Do it yourself
| |||
| ||||
Model: Beta 300rr
To replace the rear shock absorber on the Beta 300RR, you need to loosen the bolts that secure it at both the top and bottom. Once these are loosened, you can remove the screws that secure the rear side mudguard of the bike. When this is removed, you can slide the shock absorber out of its housing, allowing you to insert the new replacement part. This should be secured with the appropriate bolts, and finally, you can remount the rear mudguard.
Updated on 20 May 2026 by ScegliAuto
Video tutorial
Related tutorials
300rr
The replacement of the rear brake pads of the Beta 300RR can be carried out by loosening the screws that fix it to the corresponding housing, which i…
300rr
To replace the fork on the Beta 300RR, loosen the bolts securing the front wheel of the motorcycle so that it can be removed after disconnecting the …
300rr
To replace the rear brake pads on the Beta 300RR, loosen the screws that secure the caliper to its housing on the rear brake disc. Once the securing …
|
How to Replace the Engine Cover on a Honda CB 650R
This guide provides instructions for removing and replacing the engine cover on a Honda CB 650R motorcycle, following these simple steps. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. Then, unscrew all the screws from the cover or engine casing found on the right, as shown in the video. At this point, install the new cover, ensuring to replace the gasket and clean the base thoroughly. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.391
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
