Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the clutch lever of the BMW S1000R

Model: Bmw S1000r
Part:

Video tutorial

The instructions in this guide will show us how to disassemble and replace the clutch lever of the BMW S1000R, in simple steps. First, we put the motorcycle on the stand and start unscrewing the clutch lever screw, using a wrench to hold the lower nut in place; then we remove the clutch lever, as shown in the video.

At this point, we install the new original clutch lever, fixing it correctly; then we adjust the lever travel, consequently changing the clutch engagement, following the video tutorial until the end!


Posted on 24 September 2025 by ScegliAuto


Related tutorials

How to Replace the Spark Plugs on a BMW S1000R
How to Replace the Spark Plugs on a BMW S1000R
S1000r This guide provides the main instructions on how to remove and replace the spark plugs on the BMW S1000R engine. First, place the bike on a stand and…
How to reset the service on a BMW S1000R?
How to reset the service on a BMW S1000R?
S1000r In this tutorial, you will see how to reset the service on a BMW S1000R, a very simple and quick operation. Before doing this, you must complete all …
How to Remove the Front Wheel of the BMW S1000R
How to Remove the Front Wheel of the BMW S1000R
S1000r In this brief and simple guide, learn how to remove and replace the front wheel and tyre of the BMW S1000R motorcycle by following the instructions b…

How to Replace the Air Filter on the Kawasaki Ninja 1000 SX?

In this tutorial, you will see how to replace the air filter on the Kawasaki Ninja 1000 SX, a very simple and quick operation. First, remove the seat, then take off both side panels by unscrewing the respective screws and unscrew the two bolts located at the front of the fuel tank. Next, lift the tank, support it with a rope if necessary, and remove the top cover of the airbox. At this point, extract the old filter, clean the inside of the housing from any dirt residue, and fit the new part by reversing the procedure.

Watch the video!


by ScegliAuto

More videos